Oasis S L4-2253cc 2.3L SOHC VTEC MFI (1998)
Air Bag Control Module: Vehicle Damage Warnings
SRS Unit
- Take extra care when painting or doing body work in the area below the dashboard. Avoid direct exposure of the SRS unit or wiring to heat guns,
welding, or spraying equipment.
- Disconnect the airbag connector(s) before disconnecting SRS harness connectors.
- After any degree of frontal body damage, or after a collision without airbag deployment, inspect the SRS unit for physical damage. If it is dented,
cracked, or deformed, replace it.
- Be sure the SRS unit is installed securely.
- Do not disassemble the SRS unit.
- Store the SRS unit in a cool (less than about 104°F/40°C) and dry (less than 80% humidity, no moisture) place. Do not spill water or oil on the SRS
unit, and keep it away from dust.
- During installation or replacement, be careful not to bump (impact wrench, hammer, etc.) the area around the SRS unit. The airbags could accidentally
deploy and cause damage or injury.
