Oasis S L4-2253cc 2.3L SOHC VTEC MFI (1998)
Ball Joint: Service and Repair
Ball Joint
FRONT BALL JOINT REPLACEMENT
TOOL REQUIRED
-
07HAF-SF10110 Ball Joint Remover/Installer
-
07HAF-SF10130 Ball Joint Remover Base
-
07HAF-SF10120 Ball Joint Installer Base
-
07GAG-SD40700 Ball Joint Boot Clip Guide
1. Remove the knuckle, then remove the hub unit from the knuckle.
2. Remove the boot by prying the set ring off.
3. Check the boot for deterioration and damage, and replace it if necessary.
4. Install the special tools on the ball joint, then tighten the castle nut.
5. Position the special tools over the ball joint as shown, then set the assembly in a vise. Press the ball joint out of the knuckle.
6. Place the ball joint in position by hand.
7. Install the special tools over the ball joint as shown, then press the ball joint in.
8. Install the ball joint boot and set ring using the special tool.
9. Install the hub unit onto the knuckle.
10. Install the knuckle.
11. Check the front wheel alignment, and adjust if necessary.
