Oasis S L4-2253cc 2.3L SOHC VTEC MFI (1998)
Shift Interlock Solenoid: Testing and Inspection
Shift Lock Solenoid Test
1. Remove the steering column covers.
2. Disconnect the shift lock solenoid 2P connector.
3. Connect battery power to the No. 1 terminal and ground to the No. 2 terminal of the solenoid momentarily.
NOTE:
^
Do not connect power to the No. 2 (-) terminal (reverse polarity) or you will damage the diode inside the solenoid.
^
Check that the shift lock stop does not protrude when the shift lock solenoid is ON.
^
Check that the shift lock stop protrudes more than 7.5 mm (0.30 in) when the shift lock solenoid is OFF.
4. Check that the shift lock releases when the release lever is pushed, and check that it locks when the release lever is released.
5. If the solenoid does not work, replace the solenoid.
