Oasis S L4-2253cc 2.3L SOHC VTEC MFI (1998)
Shift Cable: Service and Repair
ADJUSTMENT
SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.
1. Remove the access cover from the lower column cover.
2. Shift to [N] position, then remove the lock pin from the cable adjuster.
3. Check that the hole in the cable adjuster is perfectly aligned with the hole in the shift lever link. There are two holes in the cable adjuster. They are
positioned 90° apart to allow cable adjustments in 1/4 turn increments.
4. If the hole is not perfectly aligned, loosen the lock nut on the shift cable, and adjust as required.
5. Tighten the locknut.
6. Install the lock pin on the adjuster. If you feel the lock pin binding as you reinstall it, the cable is still out of adjustment and must be readjusted.
7. Make sure the lock pin is seated securely in the adjuster.
NOTE: Replace the lock pin if it does not snap over the cable adjuster securely.
8. Move the shift lever to each gear, and verify that the A/T gear position indicator follows the A/T gear position switch.
9. Start the engine, and check the shift lever in all gears. If any gear does not work properly, refer to troubleshooting.
10. Insert the ignition key into the key cylinder on the upper column cover, and verify that the shift lock lever is released.
REPLACEMENT
SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.
1. Remove the center console and side cover.
2. Remove the steering lower cover and the column covers.
3. Shift to [N] position, then remove the lock pin from the cable adjuster.
