Pickup 2WD L4-2254cc 2.3L SOHC (4ZD1) MFI (1994)
Fig. 1 Lower Fan Shroud Retaining Clips
- Remove two clips from upper fan shroud and lower fan shroud.
4. Upper fan shroud
- Remove four fixing bolts from radiator and upper fan shroud.
5. Fan and fan clutch
- Remove four fixing nuts from fan and fan clutch and fan pulley.
6. Power steering pump drive belt (If so equipped)
- Loosen two fixing bolts from power steering pump adjust plate and bracket.
7. Air Conditioning compressor idler pulley
- Loosen the idler pulley nuts.
Remove two fixing bolts from idler pulley and cylinder block.
8. Air Conditioning compressor drive belt
9. Generator drive belt
- Loosen three fixing bolts from generator and adjust plate.
10. Water pump pulley
- Remove four fixing nuts from water pump pulley hub and water pump pulley.
11. Starter motor
- Remove two fixing bolts from starter motor and rear plate.
12. Crank pulley
- Attach the special tool to the cavity of starter motor
Flywheel holder: J-38674
-
Remove the crank pulley fixing bolt.
13. Timing belt upper cover
14. Timing belt lower cover
15. Water pump
-
Remove four fixing bolts and one nut from water pump body and cylinder body.
INSTALLATION
1. Install water pump.
- Tighten the water pump fixing bolts to the specified torque.
Torque N.m (lb.ft.) 19 (14)
- Tighten the water pump fixing nut to the specified torque.
Torque N.m (lb.ft.) 25 (20)
2. Timing bolt lower cover.
- Tighten the timing belt lower cover fixing bolts to the specified torque.
Torque N.m (lb.ft.) 6 (4)
3. Timing belt upper cover.
- Tighten the timing belt upper cover fixing bolts to the specified torque.
Torque N.m (lb.ft.) 6 (4)
4. Crank pulley.
- Tighten the crank pulley fixing bolt to the specified torque.
Torque N.m (lb.ft.) 122 (90)
5. Starter motor.
6. Water pump pulley.
- Temporary tighten the water pump pulley fixing nuts.
7. Generator drive belts.
- Tighten the generator fixing bolts.
8. Air Conditioning compressor drive belt.
9. Air Conditioning compressor idler pulley.