Pickup 2WD L4-2254cc 2.3L SOHC (4ZD1) MFI (1994)
Ignition Cable: Service and Repair
REMOVAL
1. Remove spark plug wire
-
Disconnect from distributor and spark plug.
INSPECTION
1. Check the cable for broken insulation.
-
If there is broken insulation, the cable must be replaced.
2. Check the terminals for corrosion and looseness.
-
If the terminals are corroded or loose, the cable must be replaced.
3. Measure the cable resistance.
-
If the measured resistance deviates from the specified value, the cable must be replaced.
Cable Resistance: 9.6 - 22.4 K Ohms
NOTE:
-
The cable contains a synthetic conductor which is easily damaged.
-
Never stretch or kink the cable.
-
Never stick a needle or the pointed end of a probe into the cable during a timing check. An increase in resistance will occur at that point,
causing the cable to burn.