Pickup 2WD V6-3137cc 3.1L (CPC) (1991)
/Page-324001.png)
Throttle Position Sensor: Service and Repair
TPS
SERVICE INSTRUCTIONS
Before installation, apply Loctite 262, or equivalent, to fastener screws.
REMOVE OR DISCONNECT
-
Air cleaner.
-
Negative battery cable.
-
Electrical connector.
-
Two screws, lock washers and retainers.
-
Sensor.
INSTALL OR CONNECT
-
With throttle valve in closed position, install sensor on TBI unit, making sure TPS pickup lever is located ABOVE tang on throttle actuator
lever.
-
Two retainers, lock washers and screws.
-
Electrical connector.
-
Air cleaner.
-
Negative battery cable.
