Rodeo (2WD) L4-2559cc 2.6L SOHC (4ZE1) (1991)
Throttle Position Switch: Adjustments
-
Open throttle valve.
Throttle Stop Screw
-
Place a 0.024 in (0.6 mm) feeler gauge on top of stop screw and close linkage onto feeler gauge.
-
Remove wiring connector from throttle switch.
Throttle Valve Switch
-
Connect ohmmeter to pin P and pin I. Ohmmeter should show continuity (closed circuit).
-
If ohmmeter does not show continuity, loosen throttle valve switch mounting screws slightly and rotate switch just to point where continuity is
attained.
-
Tighten screws.
NOTE: Continuity should stop immediately after throttle pedal is pressed.
-
Move ohmmeter lead from pin I to pin F and verify that continuity exists with throttle linkage wide open.