Rodeo (2WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
Crankshaft Position Sensor: Service and Repair
REMOVE
1.
Disconnect battery ground cable.
Protection Shield
2.
Remove exhaust and transfer protector.
3.
Disconnect front propeller shaft joint.
Crank Angle Sensor / Crankshaft Position Sensor
4.
Disconnect wiring connector at crank angle sensor.
5.
Remove mounting nut and remove sensor.
REFIT
1.
Lubricate O-ring on new sensor and fit to engine block.
2.
Fit sensor mounting bolt and tighten to:
87 in lb (10 Nm)
3.
Reconnect front propeller shaft joint and tighten to:
46 ft lb (63 Nm)
4.
Refit protection shield and tighten bolts to:
27 ft lb (37 Nm)
5.
Reconnect battery cable.