Rodeo (2WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
12. Spring
13. Overrun lock out valve
INSPECTION AND REPAIR
Visual check
^
If any damage, deformation or local wear is found in a retaining ring, return spring, spring retainer, piston or center support, replace it.
REASSEMBLY
13. Overrun lock out valve
12. Spring
^
Install overrun lock out valve and spring.
NOTE: Ensure correct assembly of valve. The spring should be located over the long small diameter end.
11. Plug
10. Pin
9. Restrictor (Fig. 7A-86)
^
Place in the lube overdrive channel in the adapter case housing.
8. Gasket
7. Transfer plate
6. Gasket
5. Center support
^
Install center support with 8 bolts.
Torque: N.m (lb.ft) 25 (18)
4. Piston
3. Springs
2. Spring seat
1. Retaining ring
^
Install twenty four springs, spring seat and retaining ring.
^
Install the tool.
^
Compress retaining ring and springs.
^
Seat snap ring in groove. Compressor: J-23327