Rodeo (2WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
REASSEMBLY
15. Turbine shaft seal rings (Fig. 7A-91)
^
Install seals with grease (petroleum jelly).
14. Overrun clutch drum
13. Piston (Fig. 7A-92, 7A-93)
^
Install the inner installer on the drum.
^
Pre-install piston into outer installer.
^
Install overrun clutch piston assembly. Use the outer installer while pushing piston into drum. Installer: J-38555
12. Diaphragm spring
11. Overrun clutch release spring retainer
10. Roller clutch assembly
9. Overrun roller clutch cam
8. Snap ring
^
Place snap ring loosely on overrun roller clutch cam.
^
Hold the compressor in a vise. Compress piston return spring with compressor.
^
Set snap ring in ring groove. Compressor: J-23327-91