Rodeo (2WD) V6-3165cc 3.2L SOHC (6VD1) (1993)
2.
Press the release button on one of the stanchions and slide the stanchion earlier forward or backward on its slide rail until the end of the cross bar
insert frees the stanchion. Remove the cross bar insert (Figure 2). Repeat this step for the other cross bar insert.
3.
Slip the ends of the new cross bar insert into each of the two stanchions and reinstall the two holding screws (Figure 3). Repeat this step for the
other new cross bar insert.
4.
Adjust the cross bars on the slide rails, as desired.
PARTS INFORMATION
Part No.
Description
Quantity
2-90122-002-0
Cross Bar Insert
2
FLAT RATE MANUAL INFORMATION
Use the existing labor operation: