Rodeo 2WD V6-3.2L (2003)
Antenna: Service and Repair
Removal
1. Disconnect the battery ground cable.
2. Turn the antenna rod (1) counterclockwise to remove it.
3. Remove three screws and nine clips to remove the fender inner liner (2).
4. Disconnect the feeder cable connector (3) at the inside of the vehicle, remove the housing bracket screw, turn the lock nut counterclockwise to
remove it together with the base mold and then remove the housing.
Installation
To install, follow the removal steps in the reverse order, noting the following point:
