Rodeo 2WD V6-3.2L (2003)
Rear Door Exterior Handle: Service and Repair
Removal
1. Disconnect the battery ground cable.
2. Remove the door trim panel.
-
Refer to Rear Door Lock Assembly.
3. Peel the upper half of the waterproof sheet
-
Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.
4. Disconnect the locking link and remove fixing bolts to remove the outside handle.
Installation
To install, follow the removal steps in the reverse order, noting the following point:
1. Check that the outside handle operates smoothly.
2. Tighten the outside handle fixing bolts to the specified torque.
Torque: 9 N.m (78 lb in)