Rodeo 2WD V6-3.2L (2003)
10. Move the front wheels to the straight ahead position, then use steering wheel remover J-29752 to remove the steering wheel.
Caution: Never apply force to the steering wheel shaft a hammer or other impact tools in an attempt to remove the steering wheel. The steering
shaft is designed as an energy absorbing unit
WARNING: THE INFLATOR MODULE SHOULD ALWAYS BE CARRIED WITH THE TRIM COVER AWAY FROM YOUR
BODY AND SHOULD ALWAYS BE LAID ON A FLAT SURFACE WITH THE URETHANE SIDE UP. THIS IS NECESSARY
BECAUSE A FREE SPACE IS PROVIDED TO ALLOW THE AIR CUSHION TO EXPAND IN THE UNLIKELY EVENT OF
ACCIDENTAL DEPLOYMENT. OTHERWISE, PERSONAL INJURY MAY RESULT.
11. Remove steering column cover.
12. Disconnect the wiring harness connectors located under the steering column.
13. Remove the combination switch assembly with SRS coil.
14. Remove snap ring.
15. Remove cushion rubber.
16. Remove shift lock cable (for A/T).
17. Disconnect the starter switch harness connector located under the steering column then remove lock cylinder assembly.
Installation
1. Install lock cylinder assembly.
2. Install shift lock cable (for A/T).
