Rodeo 2WD V6-3.2L (2003)
3. Install cushion rubber.
4. Install snap ring.
5. Install Combination switch and SRS coil assembly. After installation of combination switch assembly, connect the combination switch wiring
harness connector and the SRS 2-way connector located under the steering column.
6. Turn the SRS coil counter clockwise to full, return about 3 turns and align the neutral mark.
Caution: Turn the SRS coil counter clockwise until some resistance is felt, or damage may occur to the SRS coil.
7. When installing the steering column cover, be sure to wire (through each harness) as illustrated so that the harnesses starter switch, combination
switch and SRS coil may not catch wiring.
8. Install steering wheel by aligning the setting marks made during removal.
Caution: Never apply force to the steering wheel shaft a hammer or other impact tools in an attempt to remove the steering wheel. The steering
shaft is designed as an energy absorbing unit
