Rodeo 2WD V6-3.2L (2003)
Keyless Entry Module: Service and Repair
Anti-Theft & Keyless Entry Controller
Removal
1. Disconnect the battery ground cable.
2. Remove the glove box from the instrument panel assembly (1).
-
Refer to the Instrument Panel Assembly in Body Structure.
3. Remove the anti-theft & keyless entry controller (2).
-
Disconnect the connector.
-
Remove two fixing screws.
Installation
To install, follow the removal steps in the reverse order.
Anti-theft & Keyless Entry Control Unit Replacement
1. Remove and install the control unit.
-
Refer to Anti-theft & Keyless Entry Control Unit Removal and Installation.
2. Register ID code.
-
Refer to ID Code Registration
3. Check that the keyless entry system works normally.