Rodeo 2WD V6-3.2L (2003)
Wheel Hub: Service and Repair
Front Hub and Disc (2WD Model)
Disassembly
1. Raise the vehicle with a jack. Support the frame with chassis stand.
2. Remove the brake caliper from the bracket. Secure the caliper with a wire so that it does not interfere with the work process.
3. Remove the disk rotor.
Apply penetrating oil to the bearing and disc rotor contact surfaces if the surfaces are stuck together because of rust.
4. Inspect the hub unit bearing.
5. Use a dial gauge to measure the bearing axial rattle.
Bearing axial rattle: 0.05 mm max
If abnormal conditions are discovered during inspection, go to Step 6. If there are no abnormal conditions, reassemble the front disc rotor and
caliper.
NOTE: Hub, wheel bearing and spindle is integrated to the hub unit bearing so it must not be disassembled. If it has abnormal rattle or noise,
replace the hub unit bearing.
