Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Removing Snap Ring
9. Snap ring.
^
Push in the primary piston and remove the snap ring from the cylinder body
10. Primary piston assembly
^
Do not remove the spring from the piston.
11. Secondary piston assembly
^
Do not remove the spring from the piston.
12. Cylinder assembly
INSPECTION AND REPAIR
Visual Check - Make necessary parts replacement if wear, distortion, cuts, nick, corrosion, or other abnormal condition are found. Check the
following parts.
-
Cylinder body
-
Piston cup and spring
-
Reservoir
-
Grommet
-
Cover
-
Diaphragm
CLEAN
-
Clean all parts in clean denatured alcohol.
-
Dry with unlubricated compressed air.
-
Blow out all passages in the master cylinder.
REASSEMBLY
Cylinder Assembly
1. Cylinder assembly.
^
Lubricate the master cylinder bore with clean rubber grease. (arrowed portion of image)