Rodeo LS 4WD V6-3.2L (1998)
^
Clean the ground area and fastening bolt thoroughly with a wire brush.
^
Replace bolt if damaged or heavily corroded.
2.
Reinstall the P-6 ground terminal with the above bolt and tighten using hand tools.
^
Torque the P-6 ground terminal bolt to (14 N.m) 10 lb.ft.
IMPORTANT
Do not use air/power tools when tightening. Over-tightening may occur. Use only hand tools and torque the bolt by hand. Do not over-tighten
or under-tighten the bolt.
PARTS INFORMATION
WARRANTY CLAIM INFORMATION
This service bulletin is for information only.
Disclaimer