Rodeo LS 4WD V6-3.2L (1998)
[VALUES] B+
[YES]
Go to Step 9.
[NO]
Go to Step 8.
8. Repair the open black wire ground for the shield which prevents stray electromagnetic pulses from affecting the knock signal.
[YES]
Verify repair.
9. a. Reconnect the wire harness if it was previously disconnected in Step 7.
b. Set a DVM to AC voltage.
c. With the DVM, backprobe the PCM connector at A2.
d. Tap the engine lift bracket with a socket extension.
e. Did the DVM show an increase in AC voltage while tapping on the lift bracket?
[YES]
System OK.
[NO]
Go to Step 10.
10. Replace the knock sensor and verify repair.