Rodeo LSE 4WD V6-3.2L (2000)
10. Disconnect the locking links then remove the door lock assembly fixing screws and door lock assembly.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Apply chassis grease to the lock assembly and striker moving surface.
2. Install the regulator handle as shown in the illustration, if equipped without power windows.
3. Tighten the door lock assembly fixing screws to the specified torque.
Torque: 7 N.m (61 lb.in)
4. Check that the door lock operates smoothly.