Rodeo LSE 4WD V6-3.2L (2000)
If the seal was removed from retainer for replacement, apply engine oil to the oil seal lip and install the oil seal using J-39201 oil seal installer.
3. Flywheel (9)
1. Thoroughly clean and remove the oil from the threads of crankshaft.
2. Remove the oil from the crankshaft and flywheel mounting faces.
3. Mount the flywheel on the crankshaft and then install the washer.
4. Hold the crankshaft to prevent from rotating then install the bolts in the order shown to the specified torque.
Torque: 54 Nm (40 ft. lbs.)
Note: Do not reuse the bolt and do not apply oil or thread lock to the bolt.
