Rodeo LSE 4WD V6-3.2L (2000)
Valve Cover: Service and Repair
Cylinder Head Cover RH
Cylinder Head Cover RH
Removal
1. Disconnect battery ground cable.
2. Disconnect ventilation hose from cylinder head cover.
3. Disconnect three ignition coil connectors from ignition coils and remove harness bracket bolts on cylinder head cover then remove ignition coil
fixing bolts on ignition coils and remove ignition coils.
4. Remove heater pipe fixing bolts from the bracket.
5. Disconnect fuel injector harness connector then remove fuel injector harness bracket bolt.
6. Remove Exhaust Gas Recirculation (EGR) pipe.
^
Remove flare nut from EGR valve.
^
Remove fixing bolt of EGR pipe bracket on rear end cylinder head.
^
Remove two fixing bolt and nut on exhaust manifold.
7. Remove eight fixing bolts then the cylinder head cover.
Installation
