isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

ABOUT US
Manifold Absolute Pressure Sensor <--> [Manifold Pressure/Vacuum Sensor]|Locations|Page 2191 > < Manifold Absolute Pressure Sensor <--> [Manifold Pressure/Vacuum Sensor]|Locations|Page 2189

Rodeo LSE 4WD V6-3.2L (2000)

Page 2
background image

Steps 1 - 3

Steps 4 - 7

Test Description

IMPORTANT:  Be sure to used the same diagnostic test equipment for all measurements.

The Number(s) below refer to the step number(s) on the Diagnostic Chart.
2. Applying 34 kPa (10 Hg) vacuum to the MAP sensor should cause the voltage to be 1.5 - 2.1 volts less than the voltage at step 1. Upon applying

vacuum to the sensor, the change in voltage should be instantaneous. A slow voltage change indicates a faulty sensor.

Manifold Absolute Pressure Sensor <--> [Manifold Pressure/Vacuum Sensor]|Locations|Page 2191 > < Manifold Absolute Pressure Sensor <--> [Manifold Pressure/Vacuum Sensor]|Locations|Page 2189