Rodeo LSE 4WD V6-3.2L (2000)
Installation
1. Install inflator module.
2. Support the module and carefully connect the module connector and horn lead.
Note: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
3. Secure the module with one bolt to relieve weight on the wire connector and tighten bolts to specified sequence as illustrated.
Torque: 8 Nm (69 inch lbs.)
4. Connect the yellow 2-way SRS connector located under the steering column.
5. Connect the battery "-" terminal cable.
6. Set ignition to "ON" while watching warning light. Light should flash 7 times and then go OFF.