Rodeo LSE 4WD V6-3.2L (2000)
1. The sensor is installed on the core with the clip.
2. The sensor must not interfere with the evaporator core.
3. When installing the new evaporator core, install the duct sensor (2) to the evaporator core (1) specified position with the clip in the illustration.
4. O-rings cannot be reused. Always replace with new ones.
5. Be sure to apply new compressor oil to the O-rings when connecting lines.
6. Be sure to install the sensor and the insulator on the place where they were before.
7. To install a new evaporator core, add 50 cc (1.7 fl.oz.) of new compressor oil to the new core.
8. Tighten the refrigerant lines to the specified torque.
9. Apply an adhesive to the parting face of the lining when assembling the evaporator assembly.
