Rodeo LSE 4WD V6-3.2L (2000)
Accelerator Pedal Position Sensor: All Technical Service Bulletins
Engine Controls - Accelerator Pedal Position Sensor
BULLETIN NUMBER:
IB00-04-S003
ISSUE DATE:
APRIL 2000
GROUP:
ELECTRICAL
ACCELERATOR POSITION SENSOR ADJUSTMENT
AFFECTED VEHICLES
All 2000 Rodeo, Amigo, and Trooper models with Electronic Throttle equipped with V6 engines
SERVICE INFORMATION
Whenever the Accelerator Position Sensor is replaced, the sensor must be adjusted. This procedure has not been previously published. After installing
the retainer screws for the new sensor, perform the following procedure:
1.
Install the Tech 2 and turn the key to the "ON" position.
2.
Under Engine Data, scroll down to the AP1 percentage opening value.
3.
Adjust the Accelerator Position Sensor (APS) until the percentage of AP1 opening is between 10% and 13%.
4.
Using a DVOM, check the set voltage of AP1. The set voltage, after the percentage is set, will be 0.6 volts at pin # 5 of the C-48.
