Rodeo LSE 4WD V6-3.2L (2000)
be reused after lapping the face.
Relief Valve
The sliding face of the valve must be free from burrs and damage. The parts with minor scores may be reused after smoothing with emery cloth
(#800 or finer).
Shaft
Oil seal sliding faces must be free from a step wear which can be felt by the finger nail. Needle bearing fitting face must be free from damage and
wear.
O-ring, Oil Seal, Retaining Ring
Be sure to discard used parts, and always use new parts for installation. Prior to installation, lubricate all seals and rings with power steering fluid.
Pressure Switch
Check the switch operation as follows:
With engine idling and A/C on, turn the steering wheel fully to the left; compressor should interrupt and engine idle speed will increase. Shut off
A/C and again turn steering fully to the left; engine idle will increase. If system fails to function properly, disconnect connector at the pressure
switch and repeat system check while testing continuity across disconnected SW connector.
REASSEMBLY
1. Install oil seal to front housing. Be sure to discard used oil seal, and always use new parts for installation.
CAUTION: When installing the oil seal, be careful not to damage the oil seal contacting surface of the housing.
2. Install shaft assembly.
3. Install the vanes to rotor with curved face in contact with the inner wall of cam.
