Rodeo LSE 4WD V6-3.2L (2000)
4. Install rotor and vanes to cam.
5. Install pin to front housing.
6. Install two new O-rings to front housing. Be sure to discard used O-ring.
7. Install side plate.
CAUTION: When installing side plate, be careful not to damage its inner surface. Damaged side plate may cause poor pump performance, pump
seizure or oil leakage.
8. Install pump cartridge assembly to front housing.
9. Install snap ring to shaft end.
10. Install rear housing with a new O-ring. Be sure to discard used O-ring. Then install bolt and tighten it to specified torque. Torque to 24 Nm (17 ft.
lbs.).
11. Install suction pipe with a new O-ring. Be sure to discard used O-ring. Then install bolt and tighten it to specified torque. Torque to 10 Nm (87
inch lbs.).
12. Install relief valve and spring.
13. Install connector with a new O-ring. Be sure to discard used O-ring. Tighten the connector to specified torque. Torque to 59 Nm (43 ft. lbs.).
14. Install pressure switch assembly and tighten it to specified torque. Torque to 18 Nm (13 ft. lbs.).