Rodeo S 2WD V6-3.2L (1998)
Throttle Body: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Drain the cooling system. Refer to Cooling System.
3. Remove the accelerator cable assembly. Refer to Accelerator Cable in Engine Speed Control System..
4. Disconnect the electrical connectors:
-
Throttle position (TP) sensor.
-
Idle air control (IAC) solenoid.
-
Intake air temperature (IAT) sensor. Refer to Intake Air Temperature Sensor.
5. Disconnect the vacuum hose below the air horn.
6. Remove the intake air duct clamp.
7. Disconnect the intake air duct.
8. Disconnect the coolant lines from the throttle body.
9. Remove the bolts from the common chamber.
10. Remove the throttle body from the common chamber.
11. Remove the gasket from the upper intake manifold.
12. Remove the IAC. Refer to Idle Air Control (IAC) Solenoid.
13. Remove the TP sensor. Refer to Throttle Position (TP) Sensor.
