Rodeo S 4WD V6-3.2L (1999)
Valve Guide Replacement
1. Using Valve guide replacer: J-42899, drive out the valve guide from the combustion chamber side.
2. Apply engine oil to the outside of the valve guide. Using valve guide replacer J-42899, drive in a new valve guide from the camshaft side, and
check the valve guide height.
Valve guide upper end height: 13.0 mm (0.5118 inch)
(Measured from the cylinder head upper face)
3. Check the clearance. If the clearance is less than the specified value, ream the inside diameter of valve guide. Using a sharp 6 mm reamer, ream
the valve guide to obtain the specified clearance.
Valve Seat
1. Measure the protrusion of the valve stem when a new valve is installed in the cylinder head. If the protrusion of the valve stem exceeds the limit,
replace the valve seat insert or the cylinder head assembly.
