Rodeo S 4WD V6-3.2L (1999)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
Idle Air Control (IAC) Valve
REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the IAC electrical connector.
3. Remove the bolts and the AC valve from the throttle body.
NOTE: Do not clean the IAC valve by soaking it in solvent. The valve will be damaged as a result.
INSTALLATION
1. Install the IAC valve on the throttle body with the bolts.
Tighten:
Tighten the bolts to 1 N.m (9 lb in.).
2. Connect the IAC valve electrical connector.
3. Install the negative battery cable.
