Rodeo S 4WD V6-3.2L (1999)
Windshield Washer Switch: Service and Repair
Removal
1. Disconnect the battery ground cable.
2. Remove the front console assembly(1).
3. Remove the lower cover assembly(2).
4. Remove the knee bolster panel assembly(3).
5. Remove the instrument panel cluster assembly(4).
6. Disconnect the connector and push the lock from the back side of the instrument panel cluster assembly to remove the rear wiper and washer
switch(5).
Installation
To install, follow the removal steps in the reverse order, noting the following point:
1. Push the switch with your fingers until it locks securely.
