Rodeo S 4WD V6-3165cc 3.2L SOHC (6VD1) (1997)
6. Hub Nut.
-
Wrench: J-36827.
7. Hub and Disc Assembly.
8. ABS Sensor Ring (if so equipped).
9. Outer Bearing Outer Race.
10. Oil Seal.
11. Inner Bearing Outer Race.
12. Bolt. If necessary, replace the wheel pin in the following manner:
a. Apply a scribe mark to disc to hub.
b. Clamp the hub and disc assembly in a vise, using protective pads. Remove the 6 disc-to-hub retaining bolts.
13. Wheel Pin. Place hub on a suitable work surface and remove the when studs, as required, using a hammer.
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection. Check
the following parts:
-
Hub
-
Hub bearing oil seal Knuckle spindle
-
Disc
-
Caliper Shift on the fly system parts (Cap, Hub flange, Shim, Snap ring)
-
ABS sensor ring (If so equipped)
Installation
TOOLS REQUIRED