Rodeo S 4WD V6-3165cc 3.2L SOHC (6VD1) (1997)
^
Assemble the thrust washer to the No.3 bearing journal. The oil grooves must face the crankshaft.
2. Main bearing cap [11]
^
Apply engine oil to the threads and the seating Low faces of the bolts.
^
Install bearing caps in the order shown with the No.1 as the front most bearing cap.
^
Tighten the bolts in two steps:
a. First semi-tighten all of the bolts.
b. Second, tighten all the bolts to specification in the order shown to 39 Nm (29 ft. lbs.).
^
After the final tightening, check to see that the crankshaft rotates smoothly.
3. Rear oil seal [10]
^
Remove the oil from the cylinder block and the retainer mounting surface.