Rodeo S 4WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Crankshaft Main Bearing Seal: Service and Repair
REMOVAL
1. Transmission assembly. Refer to transmission and drivetrain.
2. Flywheel.
3. Rear oil seal.
^
Remove using a seal puller.
NOTE: Take care not to damage the crankshaft or oil seal retainer when removing oil seal.
INSTALLATION
1. Rear oil seal [3]
^
Apply engine oil to the oil seal lip, and install oil seal using installer: J-39201.
2. Flywheel [2]
^
Clean tapped holes in the crankshaft.
^
Remove oil on crankshaft and flywheel mounting surface.
NOTE:
^
Do not reuse the bolts.
^
Do not apply oil or thread lock to the bolts.
^
Tighten bolts to 54 Nm (40 ft. lbs.).
3. Transmission [1]