Rodeo S 4WD V6-3165cc 3.2L SOHC (6VD1) (1997)
/Page-1614002.png)
-
Slit the case parting face with a knife since the lining is separated when removing the evaporator.
-
Lift to remove the upper case
7. Evaporator core
8. Expansion valve
-
Tear off the insulator carefully.
-
Remove the sensor fixing clip.
-
Use a back-up wrench when disconnecting all refrigerant pipes.
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points:
1. The sensor is installed on the core with the clip.
2. The sensor must not interfere with evaporator core.
