Rodeo S 4WD V6-3165cc 3.2L SOHC (6VD1) (1997)
/Page-87001.png)
Brake Fluid Pressure Sensor/Switch: Testing and Inspection
VALVE WARNING SWITCH TEST
1. Raise the vehicle.
^
Support with suitable safety stands.
2. Attach a hose to a rear brake bleeder screw.
^
Immerse the opposite end of the hose into a container partially filled with clean brake fluid.
^
Make sure the master cylinder reservoir is full.
3. Turn the ignition key to "ON".
^
Open the bleeder screw while a helper applies moderate pressure to the brake pedal.
^
The warning light should light.
^
Close the bleeder screw before the helper releases the brake pedal.
4. Reapply the brake pedal with moderate to heavy pressure.
^
The light should go out.
5. Attach a hose to a front brake bleeder screw.
^
Immerse the opposite end of the hose into a container partially filled with clean brake fluid.
^
Make sure the master cylinder reservoir is full.
6. Turn the ignition key to "ON".
^
Open the bleeder screw while a helper applies moderate pressure to the brake pedal.
^
The warning light should light.
^
Close the bleeder screw before the helper releases the brake pedal.
7. Reapply the brake pedal with moderate to heavy pressure.
^
The light should go out.
8. Turn the ignition key off.
^
If the warning light does not light during steps 3 and 6 but does light when a jumper is connected to ground, the warning switch portion of the
valve is faulty. Do not disassemble any portion of the valve. It must be replaced.
9. Remove the safety stands.
^
Lower the vehicle.
^
Check and fill the master cylinder to the proper level.
INSPECTION OF BRAKE DIFFERENTIAL SWITCH CIRCUIT
1. Disconnect the switch connector.
2. Connect the harness side connector terminal No. 1 to ground.
3. Turn the starter switch ON and check that the bulb lights.
If the bulb does not light, inspect the bulb or cable harness between meter and the switch.