Rodeo S 4WD V6-3165cc 3.2L SOHC (6VD1) (1997)
/Page-1507002.png)
Rotor
Check that the groove in the vane is free from excessive wear and that the vane slides smoothly. When part replacement is necessary, the pump
cartridge should preferably be replaced as a subassembly.
Vane
Sliding faces of the vane should be free from wear. (Particularly the curved face at the tip in contact with the cam should be free from wear and
distortion.)
When part replacement is necessary, the pump cartridge should preferable be replaced as a subassembly.
Cam
The inner face of the arm should have a trace of uniform contact without a sign of step wear.
When part replacement is necessary, the pump cartridge should preferably be replaced as a subassembly.
Side Plate
The sliding faces of parts must be free from step wear (more than 0.01 mm), which can be felt by the fingernail.
The parts with minor scores may be reused after lapping the face.
Valve
The sliding face of the valve must be free from burrs and damage.The parts with minor scores may be reused after smoothing with emery cloth
(#800 or finer).
Shaft
Oil seal sliding faces must be free from a step wear which can be felt by the fingernail.
Needle bearing fitting face must be free from disintegration and wear.
O-ring, Oil Seal, Snap Ring
Be sure to discard used parts, and always use new parts for installation. Prior to installation, lubricate all seals and rings with power steering fluid.
