Rodeo S 4WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Seals and Gaskets: Service and Repair
TOOLS REQUIRED
^
J-37221 Companion Flange Holder
^
J-39208 Rear Oil Seal Installer
^
J-39209 Punch
^
Or Equivalent
REMOVAL
1. Rear propeller shaft. Disconnect the rear propeller shaft from the transfer case side.
2. End nut and rear companion flange:
a. Use the companion flange holder to remove the end nut.
-
Companion flange holder: J-37221.
b. Use the universal puller to remove the rear companion flange and O-ring.
3. Oil seal. Remove the oil seal from the transfer case.
INSTALLATION
NOTE: To install, follow the removal steps in the reverse order, noting the following points:
1. Oil seal:
a. Apply engine oil to the oil seal outer surfaces.
b. Apply recommended grease (BESCO L2) or equivalent to the oil seal lip.