Rodeo Sport 2WD L4-2.2L (2002)
Tailgate: Service and Repair
Tail Gate Lock Actuator
Removal
1. Disconnect the battery ground cable.
2. Remove the tailgate glass assembly and tailgate glasses stay.
-
Refer to Tailgate Glass (SWB) in Body Structure.
3. Remove the tailgate trim cover assembly.
-
Remove the two screws fixing the trim cover assembly and pull up the trim cover after detaching the clips from tailgate panel.
4. Remove the waterproof sheet.
-
Remove the waterproof sheet, taking special care so as not to break it.
5. Remove the key cylinder.
-
Disconnect the lock links.
-
Remove the key cylinder retaining clip with screw driver to remove the key cylinder.
6. Remove the hatchgate lock actuator assembly.
-
Disconnect the actuator harness connector.
-
Remove the two nuts holding hatchgate lock actuator assembly from inside.
7. Remove the outside handle.
-
Disconnect the lock link.
-
Remove the 2 bolts holding the outside handle from inside.
8. Remove the tailgate lock assembly.
-
Remove the 3 screws holding the lock assembly.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Apply chassis grease to the lock assembly and striker moving surface.
2. Tighten the tailgate lock assembly fixing screws to the specified torque.
Torque: 7 N.m (61 lb in)
3. Check that the tailgate lock operates correctly after installing it.