Rodeo Sport 2WD L4-2.2L (2002)
4. Remove bleeder with cap.
5. Remove caliper body.
Inspection and Repair
Make necessary parts replacement, if wear, damage, corrosion or any other abnormal conditions are found through inspection.
Check the following parts:
^
Rotor
^
Cylinder body
^
Cylinder bore
^
Piston
^
Guide bolt, lock bolt
^
Support bracket
Note: The piston seal, boot ring and dust boot are to be replaced each time the caliper is overhauled. Discard these used rubber parts and replace
them with new ones.
Reassembly
1. Install caliper body.
2. Install bleeder with cap and tighten the cap to the specified torque.
Torque: 8 Nm (69 inch lbs.)
3. Apply special rubber grease to the piston seal and cylinder wall, then insert the piston seal into the cylinder. The special rubber grease is included
in the repair kit.
4. When inserting the piston into the cylinder, use finger pressure only and do not use a mallet or other impact tool, since damage to the cylinder wall
or piston seal can result.
Install piston.
5. Apply special grease (approximately 1 g) to the piston and attach the dust boot to the piston and caliper. Insert the dust boot ring into the dust
boot.
6. Install guide bolt and lock bolt dust boot.
