Rodeo Sport 2WD L4-2.2L (2002)
2. Install and tighten the mounting bolt. Refer to Engine Mechanical Section.
3. Reinstall the power steering pump and bracket to the engine.
4. Reinstall the accessory drive belt.
5. Connect the negative battery cable.
IMPORTANT: PCM must re-learn Crankshaft Position when the CKP sensor is replaced. Refer to CKP sensor learn mode on the Tech 2, or
Tooth Error Correction.
REMOVAL PROCEDURE # 2
1. Disconnect battery ground cable.
2. Wiring connector from crankshaft angle sensor.
