Rodeo Sport 2WD L4-2.2L (2002)
4. Disconnect horn lead.
Installation
1. Connect air bag to wiring harness connector.
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of air bag to prevent lead wire from being pinched.
2. Connect horn lead.
3. Install air bag into steering wheel and tighten bolts to specified sequence as shown in figure.
Torque: 8.8 N.m (0.9 kg m / 78 lb in)
CAUTION: Never use the air bag assembly from another vehicle and difference model year air bag assembly. Use only the airbag assembly for
UE.
4. Enable the Supplemental Restraint System (SRS). (Refer to Enabling the SRS in this section).
