Rodeo Sport 2WD L4-2.2L (2002)
If the resistance is insufficient or play is felt when checked by moving the ball on the tie-rod, replace the tie-rod assembly.
Rubber Parts
If wear or damage is found through inspection, replace with new ones.
Reassembly
1. Install mounting rubber and dust cover (If removed).
2. Install oil line.
Torque: 13 Nm (113 inch lbs.)
3. Install tie-rod assembly with tab washer.
Apply grease to ball joint, install tie-rod and tab washer, then tighten to specified torque.
Torque: 83 Nm (61 ft. lbs.)
After tightening, bend tab washer against width across flat of inner ball joint.
4. Apply a thin coat of grease to the shaft for smooth installation. Then install bellows.
5. Install band and clip.
6. Install tie-rod end and tighten lock nut.
Torque: 98 Nm (72 ft. lbs.)
