Rodeo Sport 2WD L4-2.2L (2002)
Seals and Gaskets: Service and Repair
Rear Oil Seal (4X2)
Disassembled View
Removal
1. Raise and support vehicle with suitable jack stands.
2. Remove propeller shaft flange yoke bolts and nuts at the differential side.
Remove propeller shaft from the transmission main shaft spline.
3. Use a screwdriver to pry the rear oil seal from the rear cover.
Installation
1. Install a new oil seal (2) or (3) using the installer J-29769 (MUA) or J-38763 (TREMEC TSR).
2. Insert the splinted yoke into the transmission mainshaft spline.
3. Install the propeller shaft flange yoke to the drive pinion flange.
Torque: 63 Nm (46 ft. lbs.)
4. Check transmission fluid level.
5. Lower vehicle.
