Rodeo Sport 2WD L4-2.2L (2002)
Wiper Motor: Service and Repair
Rear Wiper Motor (LWB)
Removal
1. Disconnect the battery ground cable.
2. Remove the tailgate trim pad.
3. Remove the wiper arm/blade. Refer to Rear Wiper Arm/Blade.
4. Remove the rear wiper motor (1).
-
Disconnect the connector.
-
Remove the rear wiper motor fixing screws.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Before installing the wiper arm/blade to the motor shaft, confirm that the motor stops at the autostop position.
2. Install the wiper arm/blade so that the wiper arm (2) contact with the stopper portion (3) on the hatch gate cover (1) as shown in the figure.
3. Tighten the motor shaft nut to the specified torque.
Torque: 12 N.m (104 lb in)
4. Tighten the wiper arm nut to the specified torque.
Torque: 16 N.m (12 lb in)
