Rodeo Sport 2WD V6-3.2L (2001)
NOTE:
Check pin for fit, if pin does not fit tightly into place it will need to be replaced, otherwise the door popping sound will continue.
^
Replacing the Door Check Arm Assembly (P/N 8-97325-331-0)
8.
Raise the window to the "UP" (closed) position, and remove the front door speaker grill by gently popping it out from the lower front corner
(Figure 5).
9.
Remove the four speaker retaining screws and speaker, carefully disconnect rear speaker connectors. Set speaker aside to be reused (Figure 6).
10.
Remove the two check arm 10 mm retaining nuts (Figure 7). Refer to steps 3 and 4 to remove check arm from bracket (Figure 7)
11.
Reach inside the door panel and support the back of the Check Arm assembly. Carefully remove the Check Arm assembly through the opening in
the door (Figure 8).
