Rodeo Sport 2WD V6-3.2L (2001)
-
Remove the clip on the rear side of the regulator handle using a wire.
4. Remove the screw while pulling the inside lever toward you and then remove the inside handle.
5. Remove the 1 screw at the pull case.
6. Remove the rear corner garnish.
7. Pull out the trim panel at the 8 clip positions.
-
Disconnect the power window switch connector.
8. Remove the power window switch and pull case, if equipped.
-
Remove the fixing screws from back side of the rear door trim panel.
9. Remove the bracket.
